Licensed security guards for Dutch Flat, Placer County

Straight answers, no runaround

What Dutch Flat property owners ask before they hire us

Answers specific to Dutch Flat and the rest of Placer County — pricing, licensing, response windows, and where our legal authority stops.

Questions we get every week

Copper and tool theft in Dutch Flat — after a break-in, and how our patrols respond

Straight answers for Dutch Flat crews and property owners on scrapped copper, stolen tool trailers, siphoned fuel and repeat overnight entries.

Someone is scrapping copper off our Dutch Flat jobsite — how do we make it stop?

Copper goes during the window between rough-in and drywall, when spooled wire and pigtails sit staged in the open. What actually changes the odds is unpredictable, documented overnight presence during that phase: officers vary route and timing through electrical rooms, risers and the laydown yard instead of running the same loop at the same time. Spool and reel counts get logged at shift start and shift end, so a shortage is tied to a specific night rather than discovered a week later. Nobody can promise zero theft — but a lit, logged, obviously-staffed site in Dutch Flat is a worse target than the unwatched one two streets over.

They keep hitting our gang boxes and tool trailers. Does patrol actually help with tool theft?

Yes, and it is the most common call we get from Dutch Flat and the rest of Placer County crews. Tool theft is fast and quiet: a truck backs to the trailer, a hitch goes on, and the whole box leaves in under two minutes. Officers check hitch locks, wheel locks and puck locks on every pass, look for swapped or shimmed locks (a very common trick), and photograph the trailer tongue and box lids so you can compare condition night to night. When a vehicle is sitting where it should not be, dispatch has a plate, description and time before anything is loaded.

We just had a break-in. What should we do in the first hour?

Call the police and file a report before you clean anything up — insurers and DAs both need that report number. Then, do not move or "tidy" the scene: pried lids, cut fence panels, tire tracks, dropped tools and cut wire ends are the evidence. Photograph everything wide and close, including the point of entry. Pull whatever camera or doorbell footage exists immediately, since most systems overwrite within days. Write down which trades were on site last and who has gate keys or lock codes. Then inventory what is gone with serial numbers and model numbers if you have them.

What do we need for the insurance claim after a copper or tool theft?

Adjusters want a police report number, dated photos of the point of entry and the loss, an itemized list with serial numbers and replacement costs, and proof the property was secured — locks, fencing, gate logs, patrol records. That last piece is where most claims get argued down. Our shift reports are timestamped and geo-verified, so if a loss happens on a night we covered, you have a written record of when the site was checked and what condition things were in. Builder's risk policies also commonly sublimit copper and theft, so read yours before you assume the loss is fully covered.

How does a patrol respond when an officer actually finds someone on site?

The officer calls 911 first, from a safe distance. California private security officers do not detain, chase, search or physically confront trespassers, and ours do not. What they do is give dispatch and responding officers something usable in real time: how many people, what they are wearing, what they are carrying, vehicle make and plate, and direction of travel. Everything observed goes into a written report with photos the same night — that is the document that supports a police follow-up, a trespass letter, or your claim.

How fast does an officer get to our Dutch Flat site if something is triggered overnight?

Dispatch is staffed 24/7 by a person, not an answering service. On nights we are already running patrol in Dutch Flat, the officer is typically minutes out because they are working the corridor. If you have a standing post, response is immediate — they are already there. For call-outs on sites we do not currently cover, we will tell you honestly on the phone what arrival looks like from the nearest active unit instead of quoting a number we cannot hit.

They come back a few nights later. Can coverage be scheduled around that?

Repeat hits are the normal pattern — someone who got copper or a generator out clean will come back for the rest. After an incident we tighten coverage on the nights and hours that match the hit pattern, add checkpoints at the exact entry point they used, and deliberately randomize pass timing so the site stops being predictable. If your crew keeps finding the same gap in the fence or the same gate hardware defeated, tell us and it becomes a named checkpoint in the post orders.

Do officers document fuel siphoning and stolen generators the same way?

Yes. Fuel and generators are logged as physical checkpoints: caps and anti-siphon screens inspected, hour meters and fuel levels noted, generators and compressors confirmed chained to their anchor. If a cap is pried, a hose mark shows on the tank, or the pad is empty, it is photographed and written up that night with the time it was found, not the next morning. That timing detail is what lets you narrow which shift the loss happened on.

Should we just buy cameras instead of paying for patrol?

Cameras tell you what happened, assuming they were not the first thing stolen or spray-painted. They do not call 911, they do not notice that a fence panel was lifted and set back, and they do not check whether a trailer lock was swapped. Most Dutch Flat sites get the best result from patrol plus whatever cameras are already up — the camera gives you the recording, the officer gives you the interruption and the report. We will say plainly when a site is small enough that cameras plus better locks are the smarter spend.